![]() ![]() USB/VID_0B00&PID_0066 is the matching hardware id of this device. Ingenico Ingenico iCT250/iCT220 - two ways of downloading and installing the driver Ingenico iCT250/iCT220 is a Ports device. This driver was developed by Ingenico. Continue the overview setup procedure at step 2. Plug the USB cable's connector into a USB port on your ECR. (The USB cable should be secured as it passes through one of the three openings between the closed panel and the terminal.) j. Close the back panel until it snaps shut. Position the back panel so that its upper two corner tabs are slotted into the openings at the top of the terminal. Position the USB cable so that it sits securely in one of the three grooves at the top of the terminal. Plug the USB cable into the port labelled 'USB SLAVE' in the terminal compartment. Grip the stopper, and pull back until it tears off completely (or use a scissors to carefully snip it off). If there is no stopper, go directly to step f. If a three-pronged rubber stopper is attached, go to step e. Grip the latches simultaneously, and then pull back to raise the back panel. Turn the terminal over so that the back panel is facing you. Once the iCT250 USB driver has been installed on your ECR, connect the terminal to the ECR by following the steps below: Setting Up a USB Connection a. Install the driver on the ECR to which you will connect the terminal. Download the 'iCT250 Semi-Integrated USB' driver. Download/Install the USB driver, and Connect the Terminal to Your ECR Download/Install the USB driver, and Connect the Terminal to Your ECR 1. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |